Invite the deer to Thanksgiving dinner with them on the table. 🙂 I just did the pop can method and think I will continue with it…
I do want to experiment with using the dremil to carve the indent or make holes..
A map is a good idea, I was even thinking of a laser engraver on stainless steel.
Communities
Report
There was a problem reporting this post.
Block Member?
Please confirm you want to block this member.
You will no longer be able to:
See blocked member's posts
Mention this member in posts
Invite this member to groups
Message this member
Add this member as a connection
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.