1:30 am it’s hooked up and running. I put the steel plate and it on at the same time so as not to thermal shock it. That plate is being SLOW to warm up it was just barely over 100f when I came inside. Both coolers are downright cold to the touch. Had to go back and loosen all the hold down bolts as they were warping the 1/4 inch thick aluminum plate and it wasn’t sitting flat.
I’m starting to wonder if the TEG is removing temperature so fast the steel can’t absorb the heat as fast as the TEG is removing it. The gravel on the top was about 350f when I put it all together and started it running.
Communities
Report
There was a problem reporting this post.
Block Member?
Please confirm you want to block this member.
You will no longer be able to:
See blocked member's posts
Mention this member in posts
Invite this member to groups
Message this member
Add this member as a connection
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.