The exhaust has cleaned up a fair amount. It was completely clean until I added another load of wood then again all my wood is wet so….. The top is up just over 200F the exhaust is just below that temperature wise. Tomorrow I will attempt to start putting the module plates together. The last load of wood I just put in will be the last load for today I expect that will push the temperature of the top north of 250f and maybe even past 300f. The new firebox may not burn as clean or completely but it’s working quite well regardless. It’s dang sure easier to keep burning and doesn’t require babysitting! This is just a prototype / proof of concept anyway so I really have nothing to complain about.
Communities
Report
There was a problem reporting this post.
Block Member?
Please confirm you want to block this member.
You will no longer be able to:
See blocked member's posts
Mention this member in posts
Invite this member to groups
Message this member
Add this member as a connection
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.